Polycom ViewStation Network Card User Manual


 
Chapter 1 Getting Started
ViewStation User Guide 6 www.polycom.com
rate of 512 Kbps. Complete the following steps to connect the
ViewStation H.323 with Avaya DCP to the network:
1. Connect up to four DCP lines from RJ-45 wall jacks on the DCP
network to the connectors labeled ISDN S/T on the DCP
network interface module.
2. Locate the DCP cable shipped with the DCP network interface
module. This cable is identified with one transparent-tipped
keyed RJ-45 connector and a black-tipped non-keyed RJ-45
connector. Connect the RJ-45 cable with the black tip to the
green RJ-45 port on the back of the ViewStation as shown on
the QuickStart card.
3. Connect the opposite end of the keyed, white-tipped RJ-45
cable into the green RJ-45 port labeled
xon the DCP
network interface module.
Once the interface is properly connected, the ViewStation H.323
with Avaya DCP is ready to be configured for Ethernet LAN
connectivity. See Connecting the ViewStation to an Ethernet LAN,"
on page 8.
Note The ViewStation MP uses the Polycom Quad BRI network
interface module or the Avaya DCP network interface
module and up to four ISDN or DCP lines for network
connectivity. Use the Quad BRI or Avaya DCP network
configurations to connect your ViewStation MP to the
network.
ViewStation 128
The ViewStation 128 uses a single ISDN line and requires no
additional hardware (e.g., network interface module) for ISDN
connectivity at a maximum H.320 data rate of 128 Kbps. Complete
the following steps to connect the ViewStation 128 to an ISDN
network:
1. Connect the green-tipped RJ-45 cable to the green RJ-45 port
on the back of the ViewStation 128.
2. Connect the opposite end of the green-tipped cable to an ISDN
wall jack.
For more ISDN information, refer to “Appendix D, ISDN Information,"
on page 203.