Q-Logic 64 Switch User Manual


 
2 – Using SANbox Manager
Exiting SANsurfer Management Suite
2-6 59048-04 Rev. B
D
Click the Open Existing Fabric radio button to open the Add a New Fabric
dialog, which prompts you for a fabric name, IP address, account name, and
password. Refer to ”Adding a Fabric” on page 3-3.
Click the Open Existing Fabric View File radio button to open the Open
View dialog which prompts you to specify a fabric view file that you saved
earlier. Refer to ”Opening a Fabric View File” on page 3-4.
Click the Start Application Without Specifying a Fabric radio button to
open the SANbox Manager window shown in Figure 2-6.
Click the Open Configuration Wizard radio button to open the Config
Wizard to configure a switch, add a new switch, replace/restore a switch, or
recover or edit an IP configuration of an existing switch.
Figure 2-2. SANsurfer Window
2.3
Exiting SANsurfer Management Suite
To exit a SANsurfer application session, open the File menu and select Exit. If an
encryption key has been defined, the current fabric view is automatically saved to
your default fabric view file upon exit. The encryption key is used to encrypt the
sensitive data in the default fabric view file.
If you have not yet defined an encryption key, the Save Default Fabric View File
dialog, shown in Figure 2-7, prompts you to save the current fabric view as the
default fabric view file. Refer to ”Changing the Encryption Key for the Default
Fabric View File” on page 2-13 for information about changing this encryption key.