A – Command Line Interface
Hotreset Command
A-18 59048-04 Rev. B
D
Hotreset Command
Resets the switch for the purpose of activating the pending firmware without
disrupting traffic. This command terminates all management sessions, saves all
configuration information, and clears the alarm log. After the pending firmware is
activated, the configuration is recovered. This process takes less than 80
seconds. To save the alarm log to a file before resetting, refer to the ”Set Log
Command” on page A-44.
Authority Admin session
Syntax hotreset
Notes You can load and activate version 4.0.x firmware on an operating switch without
disrupting data traffic or having to re-initialize attached devices under the following
conditions:
The current firmware version is a 2.0, 3.0, or a 4.0.x version that precedes
the upgrade version.
No changes are being made to switches in the fabric including powering up,
powering down, disconnecting or connecting ISLs, and switch configuration
changes.
No port in the fabric is in the diagnostic state.
No zoning changes are being made in the fabric.
No changes are being made to attached devices including powering up,
powering down, disconnecting, connecting, and HBA configuration changes.
Ports that are stable when the non-disruptive activation begins, then change
states, will be reset. When the non-disruptive activation is complete, SANbox
Manager sessions reconnect automatically. However, Telnet sessions must be
restarted manually. This command clears the event log and all counters.