Filter
Top Products
A – Command Line Interface
Set Config Command
59048-04 Rev. B A-35
D
Table A-9. Set Config Port Parameters
Parameter Description
AdminState Port administrative state:
Online – Activates and prepares the port to send
data. This is the default.
Offline – Prevents the port from receiving signal
and accepting a device login.
Diagnostics – Prepares the port for testing and
prevents the port from accepting a device login.
Down – Disables the port by removing power from
the port lasers.
LinkSpeed Transmission speed: 1Gbps, 2 Gbps, or Auto. The
default is Auto.
PortType Port type: GL, G, F, FL, Donor. The default is GL.
SymbolicPortName Descriptive name for the port. The name can be up to
32 characters excluding #, semicolon (;), and comma
(,). The default is Port n where n is the port number.
ALFairness Arbitration loop fairness. Enables (True) or disables
(False) the switch’s priority to arbitrate on the loop.
The default is False.
DeviceScanEnabled Enables (True) or disables (False) the scanning of the
connected device for FC-4 descriptor information
during login. The default is True.
ForceOfflineRSCN Enables (False) or disables (True) the immediate
transmission of RSCN messages when
communication between a port and a device is
interrupted. If enabled, the RSCN message is delayed
for 200 ms for locally attached devices and 400 ms for
devices connected through other switches. The
default is False. This parameter is ignored if
IOStreamGuard is enabled.
ARB_FF Send ARB_FF (True) instead of IDLEs (False) on the
loop. The default is False.
InteropCredit Interoperability credit. The number of buffer-to-buffer
credits per port. 0 means the default (12) is
unchanged. Changing interoperability credits is
necessary only for E_Ports that are connected to
non-FC-SW-2-compliant switches. Contact your
authorized maintenance provider for assistance in
using this feature.