Filter
Top Products
4 – Managing Switches
Restoring a Switch
59048-04 Rev. B 4-31
D
2. Open the Switch menu in the faceplate display and select Restore to display
the Restore dialog shown in Figure 4-13. The Restore dialog offers a Full
Restore and a Selective Restore tab.
Figure 4-13. Restore Dialogs – Full and Selective
3. Enter the archive file name or browse for the file. This archive file must be
one that was produced by the SANbox Manager Archive function.
Configuration backup files created with the Config Backup command are not
compatible with the SANbox Manager Restore function.
4. To restore all configuration settings, click the Full Restore tab, then click the
Restore button. To restore selected configuration settings, click the
Selective Restore tab and check one or more of the following boxes, then
click the Restore button:
Network Properties: Restores all settings presented in the Network
properties dialog except the IP address. Refer to ”Network Properties”
on page 4-26.
IP Address: Restores switch IP address in addition to the other
network properties.
Switch Properties: Restores all settings presented in the Switch
properties dialog except the domain ID. Refer to ”Switch Properties” on
page 4-21.
Domain ID: Restores switch domain ID in addition to the other switch
properties.