Filter
Top Products
A – Command Line Interface
Show Log Command
59048-04 Rev. B A-71
D
level
Displays the event severity level needed to create an entry in the log. If the
severity level occurs on a port or on a component which is not defined, no entry is
made in the log. The severity levels are as follows:
Critical
Monitors critical events.
Warn
Monitors warning events.
Info
Monitors informational events.
None
Monitors none of the severity levels.
options
Displays the options used to set the component and severity level attributes.
port
Displays the ports being monitored for events. If an event occurs which is of the
defined level and on a defined component, but not on a defined port, no entry is
made in the log.
settings
Displays the current settings for component, level and port. This command is
equivalent to executing the following commands separately: Show Log
Component, Show Log Level, and Show Log Port.
Examples The following is an example of the Show Log Component command:
SANbox2 #> show log component
Current setting(s) for log component: NameServer
The following is an example of the Show Log Level command:
SANbox2 #> show log level
Current settings for log
------------------------
level Critical
The following is an example of the Show Log Options command:
SANbox2 #> show log options
Allowed options for log
-----------------------
component All, None, NameServer, MgmtServer, Zoning, Switch, Chassis, Blade,
Port, Eport, Snmp, Other,CimServer
level Critical,Warn,Info,None