Filter
Top Products
C – Messages
Switch Properties Dialog
59048-04 Rev. B C-5
D
Duplicate domain ID specified. Verify that all information is valid and retry
the configuration change. Consult the
documentation for valid configurations.
Valid domain IDs must be in the range 1 to
239, and must be unique within a fabric. If
the fabric contains SANbox with E_Port
switches, then all domain IDs must be in
the same range of sixteen values: 1…16,
17…32, and so on.
If you set this inband switch offline you will
need an ethernet connection to the switch
to put it back online. Do you want to set
switch offline?
Or
If you set this inband switch in diagnostics
mode you will need an ethernet
connection to the switch to put it back
online. Do you want to set switch in
diagnostics mode?
These changes will prevent the application
from communicating with the switch in the
fabric. Before applying the changes, verify
that the switch is reachable through its
own Ethernet port, then add a new fabric
(Fabric>Add Fabric) at the switch’s own IP
address.
IP configuration changes will not take
effect until switch is reset.
The new IP configuration has been set on
the switch, but the user has decided not to
reset the switch at this time. Arrange a
time when it is acceptable to disrupt
communications between the hosts and
storage systems, then reset the switch to
make the changes effective.
Modification of IP configuration will require
a switch reset to take effect. The reset may
disrupt traffic. Do you wish to continue?
This configuration information will not
become effective unless the switch is
reset. Resetting a switch in the fabric will
cause the servers and storage systems
attached to the fabric to lose
communications until the switch reset is
complete and the fabric has re-initialized.
If this is acceptable, then continue;
otherwise cancel the reset operation.
Table C-4. Switch Properties Dialog Messages (Continued)
Message User Action