Q-Logic 64 Switch User Manual


 
A – Command Line Interface
Show Perf Command
59048-04 Rev. B A-73
D
Show Perf Command
Displays port performance in frames/second and bytes/second. If you omit the
keyword, the command displays data transmitted (out), data received (in), and
total data transmitted and received in frames/second and bytes per second.
Authority None
Syntax show perf
byte [port_number]
inbyte [port_number]
outbyte [port_number]
frame [port_number]
inframe [port_number]
outframe [port_number]
errors [port_number]
Keywords byte [port_number]
Displays continuous performance data in total bytes/second transmitted and
received for the port group (0–15, 16–31, ...) that includes [port_number]. If you
omit [port_number], ports 0–15 are displayed. Type “q” and press the Enter key to
stop the display.
inbyte [port_number]
Displays continuous performance data in bytes/second received for the set of 16
ports (0–15, 16–31, ...) that include [port_number]. If you omit [port_number],
ports 0–15 are displayed. Type “q” and press the Enter key to stop the display.
outbyte [port_number]
Displays continuous performance data in bytes/second transmitted for the set of
16 ports (0–15, 16–31, ...) that include [port_number]. If you omit [port_number],
ports 0–15 are displayed. Type “q” and press the Enter key to stop the display.
frame [port_number]
Displays continuous performance data in total frames/second transmitted and
received for the set of 16 ports (0–15, 16–31, ...) that include [port_number]. If you
omit [port_number], ports 0–15 are displayed. Type “q” and press the Enter key to
stop the display.
inframe [port_number]
Displays continuous performance data in frames/second received for the set of 16
ports (0–15, 16–31, ...) that include [port_number]. If you omit [port_number],
ports 0–15 are displayed. Type “q” and press the Enter key to stop the display.
outframe [port_number]
Displays continuous performance data in frames/second transmitted for the set of
16 ports (0–15, 16–31, ...) that include [port_number]. If you omit [port_number],
ports 0–15 are displayed. Type “q” and press the Enter key to stop the display.