Filter
Top Products
A – Command Line Interface
Show Command
A-54 59048-04 Rev. B
D
chassis
Displays chassis component status and temperature.
config [option]
Displays switch, port, and zoning configuration attributes. Refer to the ”Show
Config Command” on page A-67.
domains
Displays list of each domain and its worldwide name in the fabric.
donor
Displays list of current donor configuration for all ports.
fabric
Displays list of each domain, symbolic name, worldwide name, node IP address,
and port IP address.
fdmi [node_wwn]
Displays information (worldwide name, manufacturer, model, and number of
ports) for the device host bus adapter given by [node_wwn]. If you omit
[node_wwn], the command displays host bus adapter information for all attached
devices. Illegal characters in the display appear as question marks (?).
interface
Displays the status of the active network interfaces.
log [option]
Displays log entries. Refer to the ”Show Log Command” on page A-70. The log is
cleared when the switch is reset or power cycled.
lsdb
Displays Link State database information
mem [count]
Displays information about memory activity for the number of seconds given by
[count]. If you omit [count], the value 1 is used. Displayed memory values are in
1K block units.
ns [option]
Displays name server information for the specified [option]. If you omit [option],
name server information for the local domain ID is displayed. [option] can have the
following values:
all
Displays name server information for all switches and ports.
Note: This keyword will display memory activity updates until [count] is
reached – it cannot be interrupted. Therefore, avoid using large
values for [count].