Filter
Top Products
A – Command Line Interface
Set Config Command
A-36 59048-04 Rev. B
D
ExtCredit Extended credits. The number of port buffer credits
that this port can acquire from donor ports. The
default is 0.
FANEnable Fabric address notification. Enables (True) or disables
(False) the communication of the FL_Port address,
port name, and node name to the logged-in NL_Port.
The default is True.
LCFEnable Link control frame preference routing. Enables (True)
or disables (False) preferred routing of frames with
R_CTL = 1100 (Class 2 responses). The default is
False. Enabling LCFEnable will disable MFSEnable.
MFSEnable Multi-Frame Sequence bundling. Prevents (True) or
allows (False) the interleaving of frames in a
sequence. The default is True. Enabling MFSEnable
disables LCFEnable and VIEnable.
MSEnable Management server enable. Enables (True) or
disables (False) management server on this port. The
default is True.
NoClose Loop circuit closure prevention. Enables (True) or
disables (False) the loop’s ability to remain in the open
state indefinitely. True reduces the amount of
arbitration on a loop when there is only one device on
the loop. The default is False.
IOStreamGuard I/O Stream Guard. Enable (Enable) or disables
(Disable) the suppression of RSCN messages. I/O
Stream Guard should be enabled only for ports
connected to initiator devices. The default is Disable.
VIEnable Enables (True) or disables (False) VI preference
routing. The default is False. Enabling VIEnable will
disable MFSEnable.
PDISCPingEnable Enables (True) or disables (False) the transmission of
ping messages from the switch to all devices on a
loop port. The default is True.
Table A-9. Set Config Port Parameters (Continued)
Parameter Description