Filter
Top Products
A – Command Line Interface
Set Setup Command
59048-04 Rev. B A-49
D
Set Setup Command
Changes SNMP and system configuration settings. The switch maintains one
SNMP configuration and one system configuration.
Authority Admin session
Syntax set setup
snmp
system
Keywords snmp
Prompts you in a line-by-line fashion to change SNMP configuration settings.
Table A-13 describes the SNMP fields. For each parameter, enter a new value or
press the Enter key to accept the current value shown in brackets.
Table A-13. SNMP Configuration Settings
Entry Description
SNMPEnabled Enables (True) or disables (False) SNMP on the switch. The
default is True.
Contact Specifies the name of the person to be contacted to respond
to trap events. The name can be up to 64 characters
excluding #, semicolon (;), and comma (,). The default is
undefined.
Location Specifies the name of the switch location. The name can be
up to 64 characters excluding #, semicolon (;), and comma
(,). The default is undefined.
Trap [1-5] Address Specifies the workstation IP address to which SNMP traps
are sent. The default address for trap 1 is 10.0.0.254. The
default address for traps 2–5 is 0.0.0.0. Addresses, other
than 0.0.0.0, for all traps must be unique.
Trap [1-5] Port Specifies the workstation port to which SNMP traps are sent.
Valid workstation port numbers are 1–65535. The default is
162.
Trap [1-5] Severity Specifies the severity level to use when monitoring trap
events. The default is Warning
Trap [1-5] Version Specifies the SNMP version (1 or 2) to use in formatting
traps. The default is 2.
Trap [1-5] Enabled Specifies whether traps (event information) are enabled or
disabled (default).