Q-Logic 64 Switch User Manual


 
A – Command Line Interface
Reset Command
59048-04 Rev. B A-27
D
Reset Command
Resets the switch configuration parameters. If you omit the keyword, the default is
Reset Switch.
Authority Admin session
Syntax reset
blade [slot_number]
config [config_name]
factory
port [port_number]
snmp
switch (default)
system
zoning
Keywords blade [slot_number]
Resets the I/O or cross-connect blade that occupies the slot given by
[slot_number]. I/O blade slot numbers are 1–4 and 6–9; cross-connect slot
numbers are 11–12.
config [config_name]
Resets the configuration given by [config_name] to the factory default values for
switch, port, port threshold alarm, and zoning configuration. If [config_name] does
not exist on the switch, a configuration with that name will be created. If you omit
[config_name], the active configuration is reset. You must activate the
configuration for the changes to take effect. Refer to Table A-3 through Table A-6
for switch, port, and port threshold alarm configuration default values.
factory
Resets switch configuration, port configuration, port threshold alarm configuration,
zoning configuration, SNMP configuration, system configuration, and zoning to
the factory default values. The switch configuration is activated automatically.
Refer to Table A-3 through Table A-8.
port [port_number]
Reinitializes the port given by [port_number]. Ports are numbered beginning
with 0.
snmp
Resets the SNMP configuration settings to the factory default values. Refer to
Table A-7 for SNMP configuration default values.
Note: Because this keyword changes network parameters, the
workstation could lose communication with the switch and
release the Admin session.