Renesas M16C/64 Network Card User Manual


 
R0E530640MCU00 User’s Manual 5. Debugging Functions
REJ10J1733-0100 Rev.1.00 Apr. 01, 2008
Page 108 of 229
2. If there is room for event counts, the event you have added from the Editor window is added to the other events as an OR
condition. If there is no room, an error message is displayed.
CAUTION
If you are doing some editing work in the Hardware Break dialog box, you cannot set hardware breaks from the event column
of the Editor window.
Figure 5.31 Hardware Break dialog box
[When adding a trace point]
1. Select the Trace Point from the popup menu displayed by double-clicking or right clicking anywhere in the event column of
the Editor window.
You can set a trace point based on a fetch to that address as a condition. => Instruction fetch condition
Double-click the instruction fetch event in the Event column of the Editor window to delete it.
CAUTION
No trace points can be set from the event column of the Editor window in the following cases.
- While editing the contents in the Trace conditions dialog box
- When selecting the Fill until stop or Fill until full of the trace mode