Filter
Top Products
R0E530640MCU00 User’s Manual 5. Debugging Functions
REJ10J1733-0100 Rev.1.00 Apr. 01, 2008
Page 79 of 229
5.1 Setting Up the Emulation Environment
When the emulator is connected, the Device setting and the Configuration properties dialog boxes are displayed. Here, select
the general options associated with the emulator. Note that the target MCU to be debugged, etc. can be set only once at startup.
5.1.1 Setting Up the Emulator at Startup
When the emulator starts, the following three dialog boxes are displayed.
(1) Device setting dialog box
Use this dialog box to select the target MCU and establish communication.
This dialog box can be redisplayed by selecting Emulator -> Device setting from the Setup menu after starting the emulator. In
this case, however, be aware that changes of the settings after starting the emulator are not reflected immediately and will be
set as the initial value when reconnecting the emulator.
(2) Configuration properties dialog box
This dialog box is displayed after the Device setting dialog box. Use this dialog box to make settings related to the emulator
and debug functions.
This dialog box can be redisplayed by selecting Emulator -> System from the Setup menu after starting the emulator. Some
options in this dialog box can have their settings changed after startup. The changeable options are displayed as in active use,
while the unchangeable options are inactive (grayed out), with their set contents only displayed.
(3) Connecting dialog box
This dialog box shows progress of boot-up processing.