Filter
Top Products
R0E530640MCU00 User’s Manual 6. Troubleshooting (Action on Error)
REJ10J1733-0100 Rev.1.00 Apr. 01, 2008
Page 212 of 229
6.2 Self-check Error
When an error occurs in the self-check, check the following.
(1) Recheck the connection of the E100 emulator main unit and MCU unit.
(2) Redownload the proper firmware.
(3) Check the self-check error log of the debugger software, and refer to the instruction described in it. (See Figure 6.2)
“Error occurred during the self-check test.”
dialog is displayed.
Click the OK button.
Check the log in the self-check dialog.
Refer to instructions described in the log.
Figure 6.2 Flowchart to check the self-check error
IMPORTANT
Notes on the Self-check:
z Be sure to execute the self-check without connecting to a converter board and the user system.
z When the self-check does not result normally (excluding the target status error), the product may be damaged.
Contact your local distributor.