R0E530640MCU00 User’s Manual 5. Debugging Functions
REJ10J1733-0100 Rev.1.00 Apr. 01, 2008
Page 117 of 229
(2) Setting OR conditions
You can choose to enable or disable the OR condition. By default, the OR condition is enabled.
To disable the OR condition, deselect the check box to the left of “OR Condition.”
If you add an event by double-clicking in the Editor window while the OR condition is disabled, the OR condition is
automatically enabled.
If you reenable the OR condition when it is disabled, the previously set event is restored with its OR condition check box
selected.
However, if a maximum of 16 events is exceeded when you have reenabled for an event, the event is restored with its OR
condition check box unselected (disabled).
Figure 5.43 Hardware Break dialog box
Table 5.11 OR condition
Type Description
1 OR condition Breakpoint is encountered when any one of the set events occurs.