R0E530640MCU00 User’s Manual 5. Debugging Functions
REJ10J1733-0100 Rev.1.00 Apr. 01, 2008
Page 81 of 229
(4) Selecting a memory expansion space
You can set this when the operation mode you have selected is Memory expansion mode or Microprocessor mode.
Select one from the following options:
Normal Mode (initial value), 4MB Mode
(5) Using PM13 (b3 of 0x000005) as set to 1
To switch the setting of the CS2 area, specify the PM13 (third bit of processor mode register 1) setting. When using the user
program with PM13 set to 1, select this check box.
(6) Using PM10 (b0 of 0x000005) as set to 1
To expand the internal reserved area, specify the PM10 (zeroth bit of processor mode register 1) setting. When using the user
program with PM10 set to 1, select this check box.
(7) Using PRG2C0 (b0 of 0x000010) and PM10 (b0 of 0x000005) as set to 1
To enable or disable the program ROM 2 area, specify the PRG2C0 (zeroth bit of program 2 area control register) setting.
When using the user program with PRG2C0 set to 1, select this check box.
(8) Setting up communication
Select the other party to which your system is connected via USB. The USB serial No. list box shows a list of the unit
identification information of USB-connected emulators. Clicking the Refresh button refreshes the unit identification
information.
(9) Performing self-diagnostics
By selecting the Start booting up on successful completion of self checking check box and clicking the OK button, it connects
your system and the emulator under the communication conditions you have set to perform hardware self-diagnostics. When
diagnostics is complete, the result is displayed. If diagnostics terminated normally, the system continues to perform boot-up
processing. If diagnostics terminated in error, the system aborts boot-up processing.