Filter
Top Products
R0E530640MCU00 User’s Manual 5. Debugging Functions
REJ10J1733-0100 Rev.1.00 Apr. 01, 2008
Page 118 of 229
(3) Setting other conditions
You can select one of five choices available: AND (Accumulation), AND (Simultaneous), Subroutine, Sequential and State
Transition. To set any condition, select the check box to the left of “Other Conditions.” By default, other conditions are
disabled (the check box to the left of “Other Conditions” is unselected).
Figure 5.44 Hardware Break dialog box
Table 5.12 Other conditions
Type Description
1 AND (Accumulation) Breakpoint is encountered when all of the set events occur irrespective of the time axis.
2 AND (Simultaneous) Breakpoint is encountered when all of the set events occur at the same time.
3 Subroutine Breakpoint is encountered when a specified event occurs within a specified address range
(Subroutine, function).
4 Sequential
Table 5. steps (forward direction) + reset point
Breakpoint is encountered when a set event occurs in a specified order.
5 State transitions 3 steps, 9 paths + reset point
Breakpoint is encountered when a set event occurs in a specified order.
The events shown in the list of each condition can be deleted by the keys Ctrl + Del.