Filter
Top Products
R0E530640MCU00 User’s Manual 5. Debugging Functions
REJ10J1733-0100 Rev.1.00 Apr. 01, 2008
Page 128 of 229
(3)
Other conditions
You can select one of five choices available: AND (Accumulation), AND (Simultaneous), Subroutine, Sequential and State
Transition. To set any condition, select the check box to the left of “Other Conditions.”
By default, other conditions are disabled (the check box to the left of “Other Conditions” is unselected).
Figure 5.52 Trace conditions dialog box
Table 5.21 Other conditions
Type Description
1 AND (Accumulation) Trace point is encountered when all of the set events occur irrespective of the time axis.
2 AND (Simultaneous) Trace point is encountered when all of the set events occur at the same time.
3 Subroutine Trace point is encountered when a specified event occurs within a specified address range
(subroutine or function).
4 Sequential 6 steps (forward direction) + reset point
Trace point is encountered when a set event occurs in a specified order.
5 State transitions 3 steps, 9 paths + reset point
Trace point is encountered when a set event occurs in a specified order.