Filter
Top Products
R0E530640MCU00 User’s Manual 5. Debugging Functions
REJ10J1733-0100 Rev.1.00 Apr. 01, 2008
Page 130 of 229
5.9.6 Setting Capture/Do not Capture Conditions
If the selected trace mode is Fill until stop, Fill until full or Fill around TP, you can specify Capture/Do not Capture conditions.
You can choose to extract only the necessary portions of trace information specified by events or delete the unnecessary
portions.
(1)
Capture/Do not Capture conditions
There are following types of conditions.
Table 5.22 Capture/Do not Capture conditions
Type Description
Between two events Cycles extracted begin when a start event occurs and end
with the next to last end event occurs (the cycle where an
end event occurs is not extracted).
Duration of an event Only cycles where a specified event occurred are extracted.
Duration of an event
occurring in a subroutine
Only cycles where a specified event occurred in a specified
address range (subroutine or function) are extracted.
Extraction
Instruction accessing
specific data
Instructions that accessed specified data are detected.
Between two events Cycles extracted begin when a start event occurs and end
with the next to last end event occurs (the cycle where an
end event occurs is not extracted).
Duration of an event Only cycles where a specified event occurred are deleted.
Deletion
Duration of an event
occurring in a subroutine
Only cycles where a specified event occurred in a specified
address range (subroutine or function) are deleted.
Select the conditions you want to set from the list box that is displayed when you select Extract or Delete in the Record
condition group box of the Trace conditions dialog box.
Figure 5.54 Record condition group box
Then click the Detail button. A page in which you can set events will be displayed.