Filter
Top Products
BLADEOS 6.5.2 Application Guide
BMD00220, October 2010 Chapter 22: Basic Redundancy 319
Configuration Guidelines
The following configuration guidelines apply to Hot links:
Ports that are configured as Hot Link interfaces must have STP disabled.
When Hot Links is turned on, MSTP, RSTP, and PVRST must be turned off.
When Hot Links is turned on, UplinkFast must be disabled.
A port that is a member of the Master interface cannot be a member of the Backup interface. A
port that is a member of one Hot Links trigger cannot be a member of another Hot Links
trigger.
An individual port that is configured as a Hot Link interface cannot be a member of a trunk.
Configuring Hot Links
Use the following commands to configure Hot Links.
RS G8124(config)# hotlinks trigger 1 enable (Enable Hot Links Trigger 1)
RS G8124(config)# hotlinks trigger 1 master port 1 (Add port to Master interface)
RS G8124(config)# hotlinks trigger 1 backup port 2 (Add port to Backup interface)
RS G8124(config)# hotlinks enable (Turn on Hot Links)