Filter
Top Products
SETUP SEND 6 - 8
Manual and automatic fax redial
If you’re sending a fax manually and the line is busy, press
Redial/Pause and then press Fax Start to try again. If you want to
make a second call to the last number you dialed, press
Redial/Pause and then press Fax Start to save time.
Redial/Pause only works when you dial using the control panel.
If you’re sending a fax automatically and the line is busy, the MFC
will automatically redial one time five minutes after the transmission.
Dual Access (Not available for color faxes)
You can place an original in the ADF and set temporary settings, dial
a number, and begin scanning the fax into memory-even when the
MFC is receiving, sending or printing a fax from memory. The LCD
shows the new job number and available memory.
1
Place the original face up in the ADF, or face down on the
scanner glass.
2
Enter the fax number.
3
Press Fax Start.
The MFC scans the original and the LCD shows the job number
(#XXX) of the fax and how much memory is available. Then the
MFC starts dialing. You can repeat Steps 1 to 3 for the next fax.
If you get a
OUT OF MEMORY
message while scanning the first
page of a fax, press Stop/Exit to cancel scanning. If you get a
OUT OF MEMORY
message while scanning a subsequent page,
you can press Fax Start to send the pages scanned so far, or
press Stop/Exit to cancel the operation.
Your machine normally uses Dual Access. However, to send a
color fax, you must use Real Time Transmission.
The Number of pages you can scan into the memory will vary
depending on the data that is printed on them.