Filter
Top Products
2-24
Cisco ONS 15327 Troubleshooting Guide, R3.4
March 2004
Chapter 2 Alarm Troubleshooting
Alarm Procedures
Procedure: Clear the AS-MT Condition
Step 1 Complete the “Clear a Loopback” procedure on page 2-128.
Step 2 If the condition does not clear, log onto http://www.cisco.com/tac for more information or call TAC
(1-800-553-2447).
2.6.14 AUD-LOG-LOSS
• Not Alarmed (NA), Non-Service Affecting (NSA)
The Audit Trail Log Loss (AUD-LOG-LOS) condition occurs when the log is 100 percent full and that
the oldest entries are being replaced as new entries are generated. The log capacity is 640 entries.
Procedure: Clear the AUD-LOG-LOSS Condition
Step 1 In node view, click the Maintenance > Audit tabs.
Step 2 Click Retrieve.
Step 3 Click Archive.
Step 4 In the Archive Audit Trail dialog box, navigate to the directory (local or network) where you want to
save the file.
Step 5 Enter a name in the File name field.
You do not have to assign an extension to the file. It is readable in any application that supports text files,
such as WordPad, Microsoft Word (imported), etc.
Step 6 Click Save.
The 640 entries will be saved in this file. New entries will continue with the next number in the sequence,
rather than starting over.
Note When you have archived a group of audit trail entries, they are no longer visible in CTC. The
entries cannot be imported into CTC.
Step 7 If the alarm does not clear, log onto http://www.cisco.com/tac for more information or call TAC
(1-800-553-2447).
2.6.15 AUD-LOG-LOW
• Not Reported (NR), Non-Service Affecting (NSA)
The Audit Trail Log Low (AUD-LOG-LOW) condition occurs when the audit trail log is 80 percent full.
Note AUD-LOG-LOW is an informational condition. It does not require troubleshooting.