Filter
Top Products
6-39
Cisco Secure ACS 3.0 for Windows 2000/NT Servers User Guide
78-13751-01, Version 3.0
Chapter 6 Setting Up and Managing User Groups
Configuration-specific User Group Settings
Step 3 From the Group list, select a group, and then click Edit Settings.
Result: The Group Settings page displays the name of the group at its top.
Step 4 From the Jump To list at the top of the page, choose RADIUS (Cisco VPN 3000).
Step 5 In the Cisco VPN 3000 Concentrator RADIUS Attributes table, determine the
attributes to be authorized for the group by selecting the check box next to the
attribute. Further define the authorization for that attribute in the field next to it.
For more information about attributes, see Appendix D, “RADIUS Attributes,” or
the documentation for network devices using RADIUS.
Step 6 To save the group settings you have just made, click Submit.
For more information, see the “Saving Changes to User Group Settings” section
on page 6-50.
Step 7 To continue specifying other group settings, perform other procedures in this
chapter, as applicable.
Configuring Cisco VPN 5000 Concentrator RADIUS Settings for a
User Group
The Cisco VPN 5000 Concentrator RADIUS attribute configurations display only
when both the following are true:
• A network device has been configured to use RADIUS (Cisco VPN 5000) in
Network Configuration.
• Group-level RADIUS (Cisco VPN 5000) attributes have been enabled on the
RADIUS (Cisco VPN 5000) page of the Interface Configuration section.
Cisco VPN 5000 Concentrator RADIUS represents only the Cisco VPN 5000
Concentrator VSAs. You must configure both the IETF RADIUS and Cisco VPN
5000 Concentrator RADIUS attributes.
Note To hide or display Cisco VPN 5000 Concentrator RADIUS attributes, see the
“Setting Protocol Configuration Options for RADIUS (Cisco VPN 5000)”
section on page 3-16.