Filter
Top Products
Appendix D RADIUS Attributes
Cisco IOS Dictionary of RADIUS AV Pairs
D-2
Cisco Secure ACS 3.0 for Windows 2000/NT Servers User Guide
78-13751-01, Version 3.0
• Cisco Building Broadband Service Manager Dictionary of RADIUS VSA,
page D-9
• Vendor-Proprietary IETF RADIUS AV Pairs, page D-10
• IETF Dictionary of RADIUS AV Pairs, page D-12
• Microsoft MPPE Dictionary of RADIUS VSAs, page D-18
• Ascend Dictionary of RADIUS AV Pairs, page D-21
• Nortel Dictionary of RADIUS VSAs, page D-29
• Juniper Dictionary of RADIUS VSAs, page D-30
Cisco IOS Dictionary of RADIUS AV Pairs
Cisco Secure ACS supports Cisco IOS RADIUS attribute-value (AV) pairs.
Before selecting AV pairs for Cisco Secure ACS, confirm that your AAA client is
a compatible release of Cisco IOS or compatible AAA client software. For more
information, see the “System Requirements” section on page 2-2.
Note If you specify a given AV pair on Cisco Secure ACS, the corresponding AV
pair must be implemented in the Cisco IOS software running on the network
device. Always take into consideration which AV pairs your Cisco IOS release
supports. If Cisco Secure ACS sends an AV pair that the Cisco IOS software
does not support, the attribute is not implemented.
Note Beginning with Cisco Secure ACS version 2.3, some RADIUS attributes do
not appear on the Group Setup page. This is because IP pools and callback
supersede the following attributes:
8, Framed-IP-Address
19, Callback-Number
218, Ascend-Assign-IP-Pool
Neither can these attributes be set via RDBMS Synchronization.