Filter
Top Products
Chapter 7 Setting Up and Managing User Accounts
Basic User Setup Options
7-14
Cisco Secure ACS 3.0 for Windows 2000/NT Servers User Guide
78-13751-01, Version 3.0
b. To specify whether one or all shared NARs must apply for the user to be
permitted access, select one of the following two options, as applicable:
• All selected NARS result in permit
• Any one selected NAR results in permit
c. Select a shared NAR name in the NARs list, and then click —> (right arrow
button) to move the name into the Selected NARs list.
Tip To view the server details of the shared NARs you have selected to apply, you
can click either View IP NAR or View CLID/DNIS NAR, as applicable.
Step 3 To define and apply a NAR, for this particular user, that permits or denies this user
access based on IP address, or IP address and port, follow these steps:
Tip You should define most NARs from within the Shared Components section so
that they can be applied to more than one group or user. For more information,
see the “Shared Network Access Restrictions Configuration” section on
page 5-7.
a. In the Network Access Restrictions table, under Per User Defined Network
Access Restrictions, select the Define IP-based access restrictions check
box.
b. To specify whether the subsequent listing specifies permitted or denied IP
addresses, from the Table Defines list, select one of the following:
• Permitted Calling/Point of Access Locations
• Denied Calling/Point of Access Locations