Filter
Top Products
3-9
Cisco Secure ACS 3.0 for Windows 2000/NT Servers User Guide
78-13751-01, Version. 3.0
Chapter 3 Setting Up the Cisco Secure ACS HTML Interface
Protocol Configuration Options for TACACS+
You can use this feature to send many TACACS+ commands to the
access device for the service, provided that the device supports the
command, and that the command syntax is correct. This feature is
disabled by default, but you can enable it the same way you enable
attributes and time-of-day access.
–
Display enable Default (Undefined) Service Configuration—If this
check box is selected, an area appears on the User Setup and Group Setup
pages that enables you to permit unknown TACACS+ services, such as
CDP.
Note This option should be used by advanced system administrators
only.
Note Customized settings at the user level take precedence over settings at the
group level.
Setting Options for TACACS+
This procedure enables you to display or hide TACACS+ administrative and
accounting options. It is unlikely that you will use every service and protocol
available for TACACS+. Displaying each would make setting up a user or group
cumbersome. To simplify setup, you can use the TACACS+ (Cisco IOS) Edit
page to customize the services and protocols that appear.
To configure the user interface for TACACS+ options, follow these steps:
Note The Cisco Secure ACS HTML interface displays any protocol option that is
enabled or has non-default values, even if you have configured that protocol
option to be hidden. This behavior prevents Cisco Secure ACS from hiding
active settings. If you later disable the option or delete its value,
Cisco Secure ACS hides the protocol option.
Step 1 Click Interface Configuration.
Step 2 Click TACACS+ (Cisco IOS).