Multicast Commands 1147
Syntax
ip mcast boundary
groupipaddr mask
no ip mcast boundary
groupipaddr mask
•
groupipaddr
— IP address of multicast group. Valid range is 239.0.0.0 to
239.255.255.255.
•
mask
— IP mask of multicast group.
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
This command has no user guidelines.
Example
The following example adds an administrative scope multicast boundary.
console(config)#interface vlan 15
console(config-if-vlan15)#ip mcast boundary 239.5.5.5 255.255.255.255
ip mroute
Use the ip mroute command to create a static multicast route for a source
range. Use the no form of this command to delete a static multicast route.
Syntax
ip mroute
source-address mask rpf-address preference
no ip mroute
source-address mask
•
source-address
— The IP address of the multicast data source.
•
mask
— The IP subnet mask of the multicast data source.
•
rpf-address
— The IP address of the next hop towards the source.
•
preference
— The cost of the route (Range: 1 - 255).
2CSPC4.X8100-SWUM102.book Page 1147 Friday, March 15, 2013 8:56 AM