Filter
Top Products
1524 Management ACL Commands
deny (management)
Use the deny command in Management Access-List Configuration mode to
set conditions for the management access list.
Syntax
deny [gigabitethernet unit/slot/port | vlan
vlan-id
|
port-channel
port-
channel-number
| tengigabitethernet unit/slot/port | fortygigabitethernet
unit/slot/port] [service
service
] [priority
priority
]
deny ip-source
ip-address
[mask
mask
|
prefix-length
] [gigabitethernet
unit/slot/port | vlan
vlan-id
|
port-channel
port-channel-number
|
tengigabitethernet unit/slot/port | fortygigabitethernet unit/slot/port]
[service
service
] [priority
priority
]
•
gigabitethernet
unit/slot/port — A valid 1-gigabit Ethernet-routed port
number.
•
vlan
vlan-id
— A valid VLAN number.
•
port-channel
port-channel-number
— A valid routed port-channel
number.
•
tengigabitethernet
unit/slot/port — A valid 10-gigabit Ethernet-routed
port number.
•
fortygigabitethernet
unit/slot/port
–
A valid 40-gigabit Ethernet-routed
port number.
•
ip-address
— Source IP address.
•
mask
mask
— Specifies the network mask of the source IP address.
•
mask
prefix-length
— Specifies the number of bits that comprise the
source IP address prefix. The prefix length must be preceded by a forward
slash (/). (Range: 0–32)
•
service
service
— Indicates service type. Can be one of the following:
telnet
,
ssh
,
http
,
https
,
tftp
,
snmp
,
sntp
, or
any
. The
any
keyword indicates
that the service match for the ACL is effectively "don’t care".
•
priority
priority
— Priority for the rule. (Range: 1–64)
Default Configuration
This command has no default configuration.
2CSPC4.X8100-SWUM102.book Page 1524 Friday, March 15, 2013 8:56 AM