Multicast Commands 1153
Example
console(config)#ip pim bsr-candidate vlan 10 16 0 interval
30
ip pim dense
Use the ip pim dense command in Global Configuration mode to
administratively configure PIM dense mode for IP multicast routing. Use the
no form of this command to disable PIM.
Syntax
ip pim dense
no ip pim dense
Default Configuration
PIM is not enabled by default.
Command Mode
Global Configuration mode
User Guidelines
Only one of sparse or dense mode can be configured on a router. It is
recommended that IGMP be enabled if PIM is enabled.
Example
console(config)#ip multicast
console(config)#ip igmp
console(config)#ip pim dense
ip pim dr-priority
The ip pim dr-priority command in Interface (VLAN) Configuration mode
to administratively configure the advertised designated router (DR) priority
value. Use the no form of this command to return the configuration to the
default.
2CSPC4.X8100-SWUM102.book Page 1153 Friday, March 15, 2013 8:56 AM