492 IP Addressing Commands
console(config-if)#
ip address (Out-of-Band)
Use the ip address command in Interface Configuration mode to set an IP
address for the out-of-band interface. Use the no form of this command to
return the ip address configuration to its default value.
Syntax
ip address {
ip-address
{
mask
|
prefix-length
} | dhcp}
no ip address
Parameter Description
Default Configuration
The out-of-band interface (service port) obtains an IP address via DHCP by
default.
Command Mode
Interface (Out-of-Band) Configuration mode
User Guidelines
When setting the netmask/prefix length on an IPv4 address, a space is
required between the address and the mask or prefix length. Setting an IP
address on the out-of-band port enables switch management over the service
port.
Parameter Description
ip-address
Specifies a valid IP address.
mask
Specifies a valid subnet (network) mask IP address.
prefix-length
The number of bits that comprise the IP address prefix. The
prefix length must be preceded by a forward slash (/). (Range: 1-
30 bits)
dhcp Obtain the out-of-band interface
address via DHCPv4.
2CSPC4.X8100-SWUM102.book Page 492 Friday, March 15, 2013 8:56 AM