UDLD Commands 777
Command Mode
Interface (physical) Config mode
User Guidelines
UDLD cannot be enabled on a port channel. Instead, enable UDLD on the
physical interfaces of a port channel.
udld port
Use the udld port command in Interface (physical) Config mode to select the
UDLD operating mode on a specific interface.
Use the no form of the command to reset the operating mode to the default
(normal).
Syntax
udld port aggressive
no udld port
Parameter Description
Default Configuration
Normal mode is configured by default when UDLD is enabled on an
interface.
Command Mode
Interface (physical) Config mode
User Guidelines
In aggressive mode, UDLD will attempt to detect a peer by sending an
ECHO packet every seven seconds until a peer is detected.
Parameter Description
aggressive Sets the port to discover peers in aggressive mode.
2CSPC4.X8100-SWUM102.book Page 777 Friday, March 15, 2013 8:56 AM