OSPF Commands 1229
exit-overflow-interval
Use the exit-overflow-interval command in Router OSPF Configuration
mode to configure the exit overflow interval for OSPF. When a router leaves
the overflow state it can originate non-default AS-external-LSAs. When set to
0, the router will not leave Overflow State until restarted. Use the no form of
the command to return the interval to the default value.
Syntax
exit-overflow-interval
seconds
no exit-overflow-interval
•
seconds
— Number of seconds after entering overflow state that a router
will wait before attempting to leave the overflow state. (Range:
0–2147483647)
Default Configuration
0 seconds is the default configuration.
Command Mode
Router OSPF Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example sets the exit overflow interval for OSPF at 10 seconds.
console(config-router)#exit-overflow-interval 10
external-lsdb-limit
Use the external-lsdb-limit command in Router OSPF Configuration mode
to configure the external LSDB limit for OSPF. If the value is -1, then there is
no limit. When the number of non-default AS-external-LSAs in a router's
link-state database reaches the external LSDB limit, the router enters
2CSPC4.X8100-SWUM102.book Page 1229 Friday, March 15, 2013 8:56 AM