Tunnel Interface Commands 1375
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode, Config mode and all Config sub-modes
User Guidelines
This command has no user guidelines.
Examples
The following examples show the parameters related to an individual tunnel
and to all tunnel interfaces.
console#show interfaces tunnel 1
Interface Link Status.......................... down
MTU size....................................... 1480 bytes
console#show interfaces tunnel
TunnelId Interface TunnelMode SourceAddress DestinationAddress
-------- --------- ---------- ------------- ----------------
1 tunnel 1 IPv6OVER4 10.254.25.14 10.254.25.10
2 tunnel 2 IPv6OVER4 10.254.20.10
tunnel destination
Use the tunnel destination command in Interface Configuration mode to
specify the destination transport address of the tunnel.
Syntax
tunnel destination
ip-address
no tunnel destination
•
ip-addr
ess — Valid IPv4 address.
Default Configuration
This command has no default configuration.
2CSPC4.X8100-SWUM102.book Page 1375 Friday, March 15, 2013 8:56 AM