IP Addressing Commands 501
console(config)#no ipv6 address
ipv6 address (OOB Port)
Use the ipv6 address command in Interface (out-of-band) Config mode to set
the IPv6 prefix on the out-of-band port. If a prefix is specified, the address
will be configured using the prefix and length A link local address in EUI-64
format may also be assigned.
The autoconfig parameter specifies that a link local address in the EUI-64
format is assigned to the interface.
The DHCP parameter indicates that the port should obtain its address va
DHCP.
Use the no form of the command to remove a specific address or to return the
address assignment to its default value. Using the no form of the command
with no parameters removes all IPv6 prefixes from the interface.
Syntax
ipv6 address {
prefix/prefix-length
[eui64] | autoconfig | dhcp}
no ipv6 address {
prefix/prefix-length
[eui64] | autoconfig | dhcp}
Parameter Description
Default Configuration
No address is assigned to the out-of-band interface by default.
Command Mode
Interface (out-of-band) Configuration mode
Parameter Description
prefix/prefix-length An IPv6 prefix in global format address format.
eui64 Formulate the prefix in EUI-64 format.
autoconfig Perform IPv6 auto-configuration.
dhcp Obtain the prefix via DHCP.
2CSPC4.X8100-SWUM102.book Page 501 Friday, March 15, 2013 8:56 AM