IP Addressing Commands 499
•
server-address
—Valid IPv4 or IPv6 addresses of the name server. (Range:
1–255 characters)
Default Configuration
No name server IP addresses are specified.
Command Mode
Global Configuration mode
User Guidelines
Server preference is determined by entry order.
Up to eight servers can be defined in one command or by using multiple
commands. Use the
show hosts
command on page 505 to display the
configured name servers.
Example
The following example sets the available name server.
console(config)#ip name-server 176.16.1.18
ipv6 address (Interface Config)
Use the ipv6 address command to set the IPv6 address of the management
interface. Use the no form of this command to reset the IPv6 address to the
default.
Syntax
ipv6 address {
prefix/prefix-length
[eui64] | autoconfig | dhcp}
no ipv6 address
•
prefix
—Consists of the bits of the address to be configured.
•
prefix-length
—Designates how many of the high-order contiguous bits of
the address make up the prefix.
•
eui64
—The optional eui-64 field designates that IPv6 processing on the
interfaces is enabled using an EUI-64 interface ID in the low order 64 bits
of the address. If this option is used, the value of prefix_length must be 64
bits.
2CSPC4.X8100-SWUM102.book Page 499 Friday, March 15, 2013 8:56 AM