320 Auto-VoIP Commands
show switchport voice
Use the show switchport voice command to show the status of Auto-VoIP on
an interface or all interfaces.
Syntax
show switchport voice [gigabitethernet unit/slot/port|
port-channel
port-
channel-number
| tengigabitethernet unit/slot/port
| fortygigabitethernet
unit/slot/port]
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC mode, Config mode and all Config sub-modes
User Guidelines
There are no user guidelines for this command.
Examples
The following example shows command output when a port is not specified:
console#show switchport voice
Interface Auto VoIP Mode Traffic Class
--------- -------------- -------------
Gi1/0/1 Disabled 6
Gi1/0/2 Disabled 6
Gi1/0/3 Disabled 6
Gi1/0/4 Disabled 6
Gi1/0/5 Disabled 6
Gi1/0/6 Disabled 6
2CSPC4.X8100-SWUM102.book Page 320 Friday, March 15, 2013 8:56 AM