OSPF Commands 1205
• always — The router assumes the role of the translator when it becomes a
border router.
• candidate — The router to participate in the translator election process
when it attains border router status.
Default Configuration
The default role is candidate.
Command Mode
Router OSPF Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example configures the translator role of the NSSA.
console(config-router)#area 20 nssa translator-role always
area nssa translator-stab-intv
Use the area nssa translator-stab-intv command in Router OSPF
Configuration mode to configure the translator stability interval of the NSSA.
Syntax
area
area-id
nssa translator-stab-intv
integer
no area
area-id
nssa translator-stab-intv
•
area-id
— Identifies the OSPF NSSA to configure. (Range: IP address or
decimal from 0–4294967295)
•
integer
— The period of time that an elected translator continues to
perform its duties after it determines that its translator status has been
deposed by another router. (Range: 0–3600)
Default Configuration
This command has no default configuration.
2CSPC4.X8100-SWUM102.book Page 1205 Friday, March 15, 2013 8:56 AM