1460 Clock Commands
multicast address ff02::101 (reserved for SNTP) for server packets on port
number 123. The client logic to handle packet contents doesn’t change with
support for IPv6 networks.
Commands in this Chapter
This chapter explains the following commands:
show sntp configuration
Use the show sntp configuration command in Privileged EXEC mode to
show the configuration of the Simple Network Time Protocol (SNTP).
Syntax
show sntp configuration
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode, Config mode and all Config sub-modes
User Guidelines
This command has no user guidelines.
show sntp configuration sntp trusted-key
show sntp server sntp unicast client enable
show sntp status clock timezone hours-offset
sntp authenticate no clock timezone
sntp authentication-key clock summer-time recurring
sntp broadcast client enable clock summer-time date
sntp client poll timer no clock summer-time
sntp server show clock
2CSPC4.X8100-SWUM102.book Page 1460 Friday, March 15, 2013 8:56 AM