LLDP Commands 571
Command Mode
Interface (Ethernet) Configuration
Default Value
LLDP-MED is disabled on all supported interfaces.
Usage Guidelines
No specific guidelines.
Example
console(config)#interface gigabitethernet 1/0/1
console(config-if-1/0/1)#lldp med
lldp med confignotification
This command is used to enable sending the topology change notification.
Syntax Description
lldp med confignotification
no lldp med confignotification
Parameter Ranges
Not applicable
Command Mode
Interface (Ethernet) Configuration
Default Value
By default, notifications are disabled on all supported interfaces.
Usage Guidelines
No specific guidelines.
2CSPC4.X8100-SWUM102.book Page 571 Friday, March 15, 2013 8:56 AM