IPv6 Multicast Commands 1175
52
IPv6 Multicast Commands
This chapter explains the following commands:
ipv6 pim (Global config)
Use the ipv6 pim command to administratively enable PIMSM for IPv6
multicast routing. Use the no form of this command to disable PIMSM for
IPv6.
Syntax
ipv6 pim
no ipv6 pim
Default Configuration
IPv6 PIMSM is disabled on the router by default.
ipv6 pim (Global config) ipv6 pim rp-candidate
ipv6 pim (VLAN Interface config)
ipv6 pim sparse (Global config)
ipv6 pim bsr-border
ipv6 pim spt-threshold
ipv6 pim bsr-candidate
ipv6 pim ssm
ipv6 pim dense show ipv6 pim
ipv6 pim dr-priority show ipv6 pim bsr
ipv6 pim hello-interval
ipv6 pim dense
ipv6 pim join-prune-interval
show ipv6 pim interface
ipv6 pim register-rate-limit
show ipv6 pim neighbor
ipv6 pim register-threshold show ipv6 pim rphash
ipv6 pim rp-address show ipv6 pim rp mapping
2CSPC4.X8100-SWUM102.book Page 1175 Friday, March 15, 2013 8:56 AM