Data Center Bridging Commands 879
lldp dcbx version
Use the lldp dcbx version command in Global Configuration mode to
configure the administrative version for the Data Center Bridging Capability
Exchange (DCBX) protocol. This command enables the switch to support a
specific version of the DCBX protocol or to detect the peer version and match
it. DCBX can be configured to operate in IEEE mode or CEE mode or CIN
mode. In auto mode, version detection is based on the peer device DCBX
version. The switch operates in either IEEE or one of the legacy modes on
each interface.
NOTE: CIN is Cisco Intel Nuova DCBX (version 1.0). CEE is converged enhanced
ethernet DCBX (version 1.06).
Use the no form of the command to reset the dcbx version to the default
value of auto.
Syntax
lldp dcbx version {auto | cin | cee | ieee}
no lldp dcbx version
Parameter Description
Default Configuration
The default version is auto.
Command Mode
Global Config
Parameter Description
auto Automatically select the version based on the peer response.
CIN Force the mode to Cisco-Intel-Nuova. (DCBX 1.0)
CEE Force the mode to CEE (DCBX 1.06)
IEEE Force the mode to IEEE 802.1Qaz
2CSPC4.X8100-SWUM102.book Page 879 Friday, March 15, 2013 8:56 AM