Auto-Install Commands 1407
Command Mode
Global Config
User Guidelines
The configuration on the master switch controls the stack as if it is a single
switch. No configuration steps need to be taken on the member switches to
synchronize the firmware.
boot auto-copy-sw allow-downgrade
Use the boot auto-copy-sw allow-downgrade command in Privileged EXEC
mode to enable downgrading the firmware version on the stack member if the
firmware version on the manager is older than the firmware version on the
member.
Use the no form of the command to disable downgrading the image.
Syntax
boot auto-copy-sw allow-downgrade
no boot auto-copy-sw allow-downgrade
Parameter Description
This command does not require a parameter description.
Default Configuration
The default value is Enable.
Command Mode
Global Configuration
User Guidelines
The configuration on the master switch controls the stack as if it is a single
switch. No configuration steps need to be taken on the member switches to
downgrade the firmware.
2CSPC4.X8100-SWUM102.book Page 1407 Friday, March 15, 2013 8:56 AM