Filter
Top Products
Configuring the WXA Series Appliance | 35
• (Optional) Comment: Text Field — Enter text that describes the device.
For example, WXA connection.
• (Optional) Management: checkboxes — Select the management methods.
• Click OK.
Step 6 Navigate to the Network > DHCP Server page.
Step 7 Under the DCHP Server Lease Scopes, click Add Dynamic.
The Dynamic Range Configuration window is displayed.
Step 8 Do the following:
a. Select the Enable this DHCP Scope checkbox.
b. Select the Interface Pre-Populate checkbox and then select port X5 in the Interface Pre-
Populate drop-down.
The information will be auto populated.
c. Click the OK button.
Note Configuring DNS is only required if you plan to use WFS Acceleration for Signed SMB. This
example assumes that the correct DNS server has already been entered in the Network >
DNS page. You can overwrite the DNS specified in the Network > DNS Server page. Click
the Edit button for the lease you want to change, and then click the DNS/WINS tab. Enter
the DNS IP Addresses in the text fields provided. You should also populate the Domain text-
field, this speeds up the WFS Acceleration configuration and auto-detection of the server in
the case that reverse DNS is not configured.
Step 9 Connect an Ethernet cable from the WXA series appliance to the X5 port on the NSA/TZ
security appliance.