Filter
Top Products
Step Task Command Command Mode
4
Return to interface configuration mode.
exit
DCB MAP
5
Apply the DCB map, created to disable the
PFC operation, on the interface
dcb-map {name |
default}
INTERFACE
6
Configure the port queues that still function
as no-drop queues for lossless traffic.
The maximum number of lossless queues
globally supported on a port is 2.
You cannot configure PFC no-drop queues
on an interface on which a DCB map with
PFC enabled has been applied, or which is
already configured for PFC using the pfc
priority command.
Range: 0-3. Separate queue values with a
comma; specify a priority range with a dash;
for example: pfc no-drop queues 1,3 or pfc
no-drop queues 2-3 Default: No lossless
queues are configured.
pfc no-drop
queuesqueue-range
INTERFACE
Data Center Bridging: Default Configuration
Before you configure PFC and ETS on a switch see the priority group setting taken into account the
following default settings:
DCB is enabled.
PFC and ETS are globally enabled by default.
The default dot1p priority-queue assignments are applied as follows:
NOTE: In Egress queue assignment (8 queues in S6000 and Z9500, 4 against in S5000 and S4810.
PFC is not applied on specific dot1p priorities.
ETS: Equal bandwidth is assigned to each port queue and each dot1p priority in a priority group.
To configure PFC and ETS parameters on an S6000 interface, you must specify the PFC mode, the ETS
bandwidth allocation for a priority group, and the 802.1p priority-to-priority group mapping in a DCB
map. No default PFC and ETS settings are applied to Ethernet interfaces.
Data Center Bridging (DCB)
259