Filter
Top Products
CLI Command Mode Prompt Access Command
u-Boot
Dell(=>)#
Press any key when the following
line appears on the console
during a system boot: Hit any
key to stop autoboot:
UPLINK STATE GROUP
Dell(conf-uplink-state-
group-groupID)#
uplink-state-group
The following example shows how to change the command mode from CONFIGURATION mode to
PROTOCOL SPANNING TREE.
Example of Changing Command Modes
Dell(conf)#protocol spanning-tree 0
Dell(config-span)#
The do Command
You can enter an EXEC mode command from any CONFIGURATION mode (CONFIGURATION,
INTERFACE, SPANNING TREE, and so on.) without having to return to EXEC mode by preceding the EXEC
mode command with the
do command.
The following example shows the output of the do command: enable, disable, exit, and configure.
Dell(conf)#do show system brief
Stack MAC : 00:1e:c9:f1:04:22
Reload Type : normal-reload [Next boot : normal-reload]
-- Stack Info --
Unit UnitType Status ReqTyp CurTyp Version Ports
---------------------------------------------------------------------
0 Management online MXL-10/40GbE MXL-10/40GbE 8-3-16-47 56
1 Member not present
2 Member not present
3 Member not present
4 Member not present
5 Member not present
Undoing Commands
When you enter a command, the command line is added to the running configuration file (running-
config).
To disable a command and remove it from the running-config, enter the no command, then the original
command. For example, to delete an IP address configured on an interface, use the no ip address
ip-address command.
NOTE: Use the help or ? command as described in Obtaining Help.
40
Configuration Fundamentals