Dell MXL 10/40GbE Switch User Manual


  Open as PDF
of 1094
 
INTERFACE mode
ip address ip-address mask [secondary]
The ip-address must be in dotted-decimal format (A.B.C.D) and the mask must be in slash format (/
xx).
Add the keyword secondary if the IP address is the interface’s backup IP address.
Example of the show ip interface Command
You can only configure one primary IP address per interface. You can configure up to 255 secondary IP
addresses on a single interface.
To view all interfaces to see with an IP address assigned, use the show ip interfaces brief
command in EXEC mode as shown in View Basic Interface Information.
To view IP information on an interface in Layer 3 mode, use the show ip interface command in
EXEC Privilege mode.
Dell(conf-if-vl-10)#do sh int vl 10
Vlan 10 is up, line protocol is up
Address is 00:1e:c9:f1:03:38, Current address is 00:1e:c9:f1:03:38
Interface index is 1107787786
Internet address is 5.5.5.1/24
Mode of IP Address Assignment : MANUAL
DHCP Client-ID: vlan10001ec9f10338
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 1000 Mbit
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 00:01:09
Queueing strategy: fifo
Time since last interface status change: 00:00:46
Management Interfaces
The IOM management interface has both a public IP and private IP address on the internal fabric D
interface.
The public IP address is exposed to the outside world for Web GUI configurations/WSMAN and other
proprietary traffic. You can statically configure the public IP address or obtain the IP address dynamically
using the dynamic host configuration protocol (DHCP).
NOTE: When you shut down a management interface, connectivity to the interface’s private IP
address is disabled.
You can access the full switch using:
Internal RS-232 using the chassis management controller (CMC). Telnet into CMC and do a connect
-b switch-id
to get console access to corresponding IOM.
External serial port with a universal serial bus (USB) connector (front panel): connect using the IOM
front panel USB serial line to get console access (Labeled as USB B).
Telnet/others using the public IP interface on the fabric D interface.
CMC through the private IP interface on the fabric D interface.
404
Interfaces