Filter
Top Products
SNMPv2-SMI::enterprises.6027.3.15.4.0.3,
SNMPv2-SMI::enterprises.6027.3.15.4.1.1.0 = INTEGER: 45420801,
SNMPv2-SMI::enterprises.6027.3.15.4.1.2.0 = INTEGER: 2,
SNMPv2-SMI::enterprises.6027.3.15.4.0 = STRING:
"ETS_TRAP_TYPE_PEER_STATE_CHANGE: ETS Peer state changed to disabled for port Te
0/44", SNMPv2-SMI::enterprises.6027.3.6.1.1.2.0 = INTEGER: 23
pfc
pfc peer state enabled
10.16.130.140 [10.16.130.140]: Trap SNMPv2-MIB::sysUpTime.0 = Timeticks:
(626100) 1:44:21.00, SNMPv2-MIB::snmpTrapOID.0 = OID:
SNMPv2-SMI::enterprises.6027.3.15.4.0.7,
SNMPv2-SMI::enterprises.6027.3.15.4.1.1.0 = INTEGER: 45420801,
SNMPv2-SMI::enterprises.6027.3.15.4.1.2.0 = INTEGER: 1,
SNMPv2-SMI::enterprises.6027.3.15.4.0 = STRING:
"PFC_TRAP_TYPE_PEER_STATE_CHANGE: PFC Peer state changed to enabled for port Te
0/44", SNMPv2-SMI::enterprises.6027.3.6.1.1.2.0 = INTEGER: 21
pfc peer state disbled
10.16.130.140 [10.16.130.140]: Trap SNMPv2-MIB::sysUpTime.0 = Timeticks:
(645794) 1:47:37.94, SNMPv2-MIB::snmpTrapOID.0 = OID:
SNMPv2-SMI::enterprises.6027.3.15.4.0.7,
SNMPv2-SMI::enterprises.6027.3.15.4.1.1.0 = INTEGER: 45420801,
SNMPv2-SMI::enterprises.6027.3.15.4.1.2.0 = INTEGER: 2,
SNMPv2-SMI::enterprises.6027.3.15.4.0 = STRING:
"PFC_TRAP_TYPE_PEER_STATE_CHANGE: PFC Peer state changed to disabled for port Te
0/44", SNMPv2-SMI::enterprises.6027.3.6.1.1.2.0 = INTEGER: 24
Enabling an SNMP Agent to Notify Syslog Server Failure
You can configure a network device to send an SNMP trap in the event of an audit processing failure due
to connectivity issues with the syslog server.
If a connectivity failure occurs on a syslog server that is configured for reliable transmission, an SNMP
trap is sent. Also a message is written to the console indicating that the configured syslog server has
failed.
The SNMP trap is sent only periodically. Meaning, when a syslog connection fails and the time-interval
between the last syslog notification and current time is greater than or equal to five minutes, a trap is
sent. This restriction applies to the console message also.
NOTE: If a syslog server failure event is generated before the SNMP agent service starts, then SNMP
trap is not sent successfully.
To enable an SNMP agent to send a trap when the syslog server is not reachable, use the following
command:
CONFIGURATION MODE
snmp-server enable traps snmp syslog-unreachable
To enable an SNMP agent to send a trap when the syslog server resumes connectivity, use the following
command:
CONFIGURATION MODE
snmp-server enable traps snmp syslog-reachable
Simple Network Management Protocol (SNMP)
861