Filter
Top Products
Example the show config Command
Example of the show ip interface Command
To view the configuration, use the show config command in INTERFACE mode or use the show ip
interface
command in EXEC privilege mode, as shown in the second example.
Dell(conf-if-te-0/16)#show conf
!
interface TenGigabitEthernet 0/16
no ip address
shutdown
Dell(conf-if-te-0/16)#
Dell#show ip interface tengig 0/16
TenGigabitEthernet 0/16 is down, line protocol is down
Internet address is not set
IP MTU is 1500 bytes
Directed broadcast forwarding is disabled
Proxy ARP is enabled
Split Horizon is enabled
Poison Reverse is disabled
ICMP redirects are not sent
ICMP unreachables are not sent
Dell#
Configuring Static Routes
A static route is an IP address that you manually configure and that the routing protocol does not learn,
such as open shortest path first (OSPF). Often, static routes are used as backup routes in case other
dynamically learned routes are unreachable.
You can enter as many static IP addresses as necessary.
To configure a static route, use the following command.
• Configure a static IP address.
CONFIGURATION mode
ip route ip-address mask {ip-address | interface [ip-address]} [distance]
[permanent] [tag tag-value]
Use the following required and optional parameters:
– ip-address: enter an address in dotted decimal format (A.B.C.D).
– mask: enter a mask in slash prefix-length format (/X).
– interface: enter an interface type then the slot/port information.
– distance: the range is from 1 to 255. (optional)
– permanent: keep the static route in the routing table (if you use the interface option) even if
you disable the interface with the route. (optional)
– tag tag-value: the range is from 1 to 4294967295. (optional)
Example of the show ip route static Command
To view the configured routes, use the show ip route static command.
Dell#show ip route static
Destination Gateway Dist/Metric Last Change
IPv4 Routing
439