Filter
Top Products
• For a 10/100/1000 Ethernet interface, enter the keyword GigabitEthernet then the slot/port
information.
• For a Gigabit Ethernet interface, enter the keyword GigabitEthernet then the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port
information.
Slot/Port, Range: Slot and Port ID for the interface. Range is entered Slot/Port-Port.
3. Assign the Primary and Secondary ports and the control VLAN for the ports on the ring.
CONFIG-FRRP mode.
interface primary int slot/port secondary int slot/port control-vlan vlan id
• For a 10/100/1000 Ethernet interface, enter the keyword GigabitEthernet then the slot/port
information.
• For a Gigabit Ethernet interface, enter the keyword GigabitEthernet then the slot/port
information.
• For a SONET interface, enter the keyword sonet then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port
information.
Slot/Port, Range: Slot and Port ID for the interface. Range is entered Slot/Port-Port.
VLAN ID: The VLAN identification of the control VLAN.
4. Configure the Master node.
CONFIG-FRRP mode.
mode master
5. Identify the Member VLANs for this FRRP group.
CONFIG-FRRP mode.
member-vlan vlan-id {range}
VLAN-ID, Range: VLAN IDs for the ring’s member VLANS.
6. Enable FRRP.
CONFIG-FRRP mode.
no disable
Configuring and Adding the Member VLANs
Control and member VLANS are configured normally for Layer 2. Their status as Control or Member is
determined at the FRRP group commands.
For more information about configuring VLANS in Layer 2 mode, refer to the Layer 2 chapter.
Be sure to follow these guidelines:
• All VLANS must be in Layer 2 mode.
Force10 Resilient Ring Protocol (FRRP)
377